Tramex Hygro-i Probe - Measure Humidity, Temperature, and Dew Point to current ASTM Standards.   --  -  Dew

The Tramex Hygro-i Probe is fast, accurate, reusable and economical.

• Pays for itself after a few uses compared to single use relative humidity probes
• Ability to check calibration at any time and know that the sensor is operating properly
• Less waste of resources so it's better for the environment
   

The all new Tramex Hygro-i Probe is the most advanced and resilient RH probe on the market today.

The Hygro-I Probes use cutting edge sensor technology to give accurate measurements even in the most demanding of on-site conditions.

Hygro-I Probe can be checked in Calibration Salts (item #SAL75) before and after use to give the user extra confidence in the probe’s performance. Probe can be used again and again, offers the best value to the user over any other system as well as the greatest accuracy.

Used in conjunction with the Tramex CMEX2 or MRH3 non-destructive moisture meters, the Hygro-i probe provides measurements of humidity, temperature, and dew-point in structural materials such as concrete flooring, walls etc.

Environmental conditions can also be measured within the building or structure allowing the user to perform in-situ and hood type RH testing to comply with ASTM F2170, F2420, BS8201:2011 and BS8203.

Hygro-i Probe Specifications :

Reusable ambient condition tests - Temperature, RH%, Dew Point, Mixing Ratio

Humidity Range: 0 % - 100 % RH

Humidity Temp Range: -40º C to 99º C, -40º F to 99º F

RH Response Time: 8 seconds

Humidity Accuracy 10% to 90% RH +/-1.8% @ 25º C / 77º F, >90% +/- 3%

Available in 3 Pack (HIPP3) or 12 Pack (HIPP12)  (Select Pack Size At Checkout)